Wiring, bypass valve to PCB, for G1 and G2 Stick Replacing them as a set

Replacing them as a set restores firm cord retention and correct spring tension

Fits directly over the existing ET-1 head

The resulting friction drags on agitation and loads the motor

Compatible with SEBO G Series vacuum models

Wiring, bypass valve to PCB, for G1 and G2 Stick Replacing them as a setThis genuine SEBO Wiring, bypass valve to PCB fits the SEBO G1 and G2. It is the harness that connects the bypass valve to the printed circuit board that governs the machine's electronics. Vibration and heat cycling loosen connectors and fatigue the conductors in this harness, and a poor link between the bypass valve and the PCB can cause erratic control behavior or a valve that does not respond. Tracing the fault to this wiring and renewing it